3194M01 CUXⅡ SERIES ELECTRONIC COUNTING SCALE OPERATION MANUAL HIJK Shinko Denshi Co., Ltd. 01-12-1998 NS
5-1. Tare 1.) Tare with actual tare load Load tare. Press T key. 2.) Tare with numerical keys. Enter tare weight with
5-2. Unit weight set (sampling) 1.) Quantity set sampling Tare the balance by pressing T key. Display : Exactly 0 . Load samples precisely
2.) Direct entering of unit weight Enter unit weight with numerical keys. Press UNT.W. SET key. Features - Good whe
3.) SCS (Automatic re-sampling system) 1. Press SCS key. Beep then flicker : on 5 * (on QUANTITY display) (*Initial quantity
5-3. Re-Sampling 1. After unit weight is set, load or add (other) samples.* *too many sampling will cause sampling error.
3.) Fixed unit weight method # Enable the bar graph when using this counting method 1. Unit weight has been set. 2. Load
Tare set 1. Enter tare weight with numerical keys. * 2. Press TARE PRESET key. *If you fail to enter weight and press num
5-7. Memory data call up in working area 1. Enter ID number with numerical keys. 2. Press No. key. (Memory data look-up.) 3. Press R.M. key. (The d
[Look up limit values] Press LMT key. Li-LO appears at Weighing display, and low limit value shows that currently set at
5-9. Function set A.) Function set 1.) Press MODE key until QUATITY display shows “ Func “ . 2.) The display then changes to “ 1
INDEX 1. SPECIFICATIONS...3 1-1. GENERAL SPECIFICATIONS...
B.) Function tables 1. SEL. limit function *1: disable 2: enable 11.Co. enable when *1: anytime 2: in stable state 12
C.) Contents of Interface FUNCTIONS DISPLAY CONTENTS Output Contents 81.dA. 1 Counting quantity data output 81.dA. 2 Weighing data
6. CALIBRATION We recommend you to calibrate the balance with a reference weight of full capacity of the scale according to the following proc
NOTES 1. To stop the calibration operation, press any key (Ex. RE, C/AC, T key) without pressing the MODE key to return to the working area. 2.
7. TROUBLE SHOOTINGS SYMPTOMS CAUSES & REMEDY No display appears * AC adapter is not connected, or the ON/OFF key is OFF. - Connect
5-9. FUNCTION SET...21 A.) FUNCTION SET...
1. SPECIFICATIONS 1-1. General Specifications Measuring System : Tuning-fork system. Sampling System : Semi-automatic counting and storing system(S
2. UNPACKING & INSTALLATION 2-1. Unpacking Unpack the container carefully. Examine the packaging and the device for any damage, and repor
2-4 Performance Test 1. Connect the AC adapter at the rear of the scale, then plug the cord in line outlet. 2. Press the ON/OFF key. All display, s
3. OPERATION KEY FUNCTIONS ON/OFF : ON/OFF key for the balance. RE : Improving unit weight by increasing samples. SCS
4. BEEP SIGNALS AND CONDITION SYMBOLS CUXII signals you various messages by four different beep signals and four symbolic letter as shown as under.
5. OPERATION Basic operation is divided into the four procedures (A) Tare if necessary (B) Unit weight set ( sampling) (C) Re-Sampling if ne
Kommentare zu diesen Handbüchern